Is the audio output mono or stereo? I cant tell from the pics
Hi there. These are being pulled from Amazon inventory so we don’t have a lot of information. Here it is on Amazon:
https://www.amazon.com/dp/B0010K6TXQ
Amazon Q&A might have some answers?
Also, there’s a manual on the Pyle product page:
Works as delivered. BT paired immediately, I had to switch the power selection to 120 volt from 230 volt, no problem. The sound level at 2 feet is 12db in a very quiet room. Sound is quite good, just going into some PSB bookshelf speakers for now. The left rack bracket was a little bent, but easily bent back to straight. The single fan blows out, pulling air from a long front vent at the top of the case through the heat sink. Perhaps a small case fan added to the front part of the heat sink will help airflow on heavier a future tinker project. Impressed by the use of a toroidal coil instead of a digital transformer. If use the bluetooth setting in a rack, I would advise using an extension antenna cable to a better bluetooth antenna. If using wired, I advise using TRS or XLR jacks and cables for a hotter signal input. This will drive the amp to stronger output and noticeably higher volume than with phono or mini jack cables.
Great amp at a fantastic price.
Look here for specs
It can be either -
as it is a 2 channel input with a stereo/bridge switch on the back.
Thanks for the specs link.
Wondering about the Bluetooth version tho. Woot photos show version 3.0. Pyle link claims version 5.0. There’s a cavernous difference between 3.0 and 5.0.
Hi there. These are being pulled from Amazon inventory so we don’t have a lot of information. Here it is on Amazon:
https://www.amazon.com/Professional-Audio-Bluetooth-Power-Amplifier/dp/B0010K6TXQ
They have the same photo on the Amazon page.